Page 73
Resetting the Receiver to Factory Defaults
Page 73
5. If you want to continue, select the
Yes
option. The receiver now
displays the
System Diagnostic Tests
screen containing further
instructions.
6. Aim both remotes at the receiver. Press one button at a time on your
DISH Network remote, while pressing the button to be taught on the
universal learning remote at the same time. Repeat this process for each
button you want to be taught to the learning remote.
Note
: Any button on the DISH Network remote that is not used with
your DISH Network receiver, will not teach the universal learning
remote.
7. You can quit the teaching mode at any time by either of the two
following methods:
•
Press any front panel button on your receiver.
•
Leave the receiver alone for at least three minutes.
8. The receiver again displays the blank
System Diagnostic Tests
screen.
You can cancel out of this screen back to your original viewing screen.
Resetting the Receiver to Factory Defaults
Use these instructions if you want to reset the receiver to be the same as
when it was shipped.
Note
:
Resetting the receiver to factory defaults discards all Favorite Lists
except
the
All Chan
and
All Sub
lists.
Note
: If you have set
any
locks on the receiver, and the receiver is locked,
these locks will be kept. If the receiver is unlocked, any such locks will be
lost. You
cannot
reset the receiver to default settings to discard a password
you have forgotten. Only the Customer Service Center can reset the receiver
to bypass a receiver lock.
1. Press the
MENU
button.
Summary of Contents for 138410
Page 107: ...Appendix Page 118 Notes...
