Page 2
113737
A
BOUT THE
R
EMOTE
C
ONTROL
•
This remote control gives you easy access to the features of DISH
Network
TM
satellite TV receivers.
•
You can set up the remote to control as many as three devices
along with the receiver. These may be TVs, VCRs, DVD players,
cable TV boxes, tuners, or audio amplifiers.
•
This remote can be used with both IR only and IR/UHF receivers
(a UHF receiver has an antenna attached to its back panel).
•
This remote cannot be used with the DISH Network Model 7100/
7200 (DishPlayer) receiver.
•
On most non-DishPVR receivers, the
SKIP BACK
button is now
the
SYSTEM INFORMATION
button.
•
With a DishPVR receiver, the DVR List, PTV List or PVR list
button functions as the PVR button. Pressing it when the remote
is in
SAT
mode will open the
PVR Recorded Events
menu.
•
With the JVC Model HM-DSR100-D-VHS, when the remote is
in
SAT
mode, the
VCR
buttons function as labelled. For
example, PLAY will start playing a videotape, STOP will stop the
tape, etc.
•
When this remote is used with a DishPVR receiver, pressing the
POUND
(#) Button opens the Alpha Search menu.
I
F YOUR RECEIVER DOES NOT RESPOND TO THIS
REMOTE
It may be that the receiver’s address was changed and is no longer set
to #1. This is important because if the receiver and remote are not set to
the same address, the remote cannot control the receiver.
To check the receiver’s address, turn off the receiver (leave the TV on),
and press the System Information or Info button on the front panel to
open the
Important System Information
screen. If the receiver
does not have such a button, pull the Smart Card to open the
Important System Information
screen. If the remote address is not
1, you will need to change address (see page 23 for instructions).
113737_02_text.fm Page 2 Monday, March 11, 2002 3:53 PM
