Remote Control Modes
113737
Page 3
R
EMOTE
C
ONTROL
S
IGNALS
The remote control uses both Infra-Red (IR) light and UHF signals to
control the satellite receiver and other devices.
•
IR light travels only short distances (40 feet or less), and cannot
go through walls or other solid objects. You must point the remote
control directly at the device, with no objects blocking the signal
path.
•
UHF signals can go through
walls but IR signals can’t. To
use UHF signals to control the
receiver, the receiver must
have a UHF antenna attached
to it’s back panel.
H
OW TO
I
NSTALL THE
B
ATTERIES
When you replace old batteries, you should
replace all of the batteries. Use batteries of
the same kind, for example, alkaline or
carbon zinc, and do not mix batteries of
different kinds.
Alkaline batteries last longer.
1. Press down on the slot in the battery
cover (on the back of the remote
control) and slide the cover off.
2. Remove all of the old batteries.
3. Insert the new batteries. Make sure to
match the plus (“+”) ends with the plus
markings on the battery case.
4. Put the battery cover back on by sliding
it back up into place.
R
EMOTE
C
ONTROL
M
ODES
To use the remote to control a device, do the following:
Note:
The remote comes already set up to control a receiver
113737_02_text.fm Page 3 Monday, March 11, 2002 3:53 PM
