Installing Batteries in the Remote Control
104333
3
I
NSTALLING
B
ATTERIES
IN
THE
R
EMOTE
C
ONTROL
The remote control comes with AAA batteries,
packaged separately. When you replace old batteries,
you should replace all of the batteries. Use batteries
of the same grade, for example, alkaline or carbon
zinc, and do not mix batteries of different grades.
Alkaline batteries provide longer battery life.
1. Press down on the slot in the battery cover
(on the back of the remote control) and slide
the cover off.
2. Insert the new batteries, making sure to match
the plus (“+”) ends with the plus markings
on the battery case.
3. Replace the battery cover by sliding the cover
back up into place.
R
EMOTE
C
ONTROL
M
ODES
To use the remote to control a device such as the satellite receiver or a
TV, you must first set up the remote to control the device, and then set
the remote to the right mode for that device.
1. Set up the remote to control the device. See Controlling a Device
on pag e15 for instructions.
2. Use the remote control mode buttons,
SAT
(satellite receiver),
TV
,
VCR
(for a VCR or a DVD player), and
AUX
(“auxiliary,”
for a cable TV box, a tuner, or an audio amplifier) to set the
remote to the right mode for the device. To change the mode
setting, press the button for the device that you want the remote
to control. The mode button’s back light turns ON to show that
the remote is set to that mode.
The following sections describe how to use the
remote control buttons. Each section describes only
the buttons that work in one remote control mode,
for example
SAT
mode or
TV
mode.
