20
118866
U
SING
W
HEN A
VCR
IS
I
NSTALLED
If you installed a VCR using the instructions in Setting Up
to Pass Satellite Programming Through Your VCR to
Your TV on page 14, but you would like to use
to
switch your TV to the preferred off-air channel, make sure
your VCR is turned off before pressing
.
16.If the information in step 2 on page 15 is a “3,”
write the numbers you circled in Table 2 into the
blank in step 21.
17.If the information in step 2 on page 15 is a “4,”
write the numbers you circled in Table 2 into the
blank in step 21, except replace the “3” with a “4.”
18.Press and hold
until both
lights turn
on (it takes about five seconds).
19.Release
.
light will flash.
20.Press the
RECALL
button.
21.Press
.
22.Press the
MUTE
button while watching
light.
23.If the
light flashes three times, go to step 24.
If
light does not flash at all, go back to step 18.
24.Press
. You should see both your TV and your
VCR change to the channel you wrote in step 21
above so that you can watch satellite programming.
25.Press the
MENU
button. If you see the satellite
receiver
Menu
screen, go to step 26. If not, go to
step 15 on page 18.
26.You are finished programming the remote control.
SAT
TV
SAT
SAT
SAT
SAT
