8
108933
I
NSTALL AN
A
TTENUATOR
Stray UHF signals can block signals from the remote control
to the receiver. To prevent blocks, you can install a 10 dB attenuator
(you can buy one from a consumer electronics parts store).
Note:
This will help keep out stray UHF signals, but also cut down
how far away you can use the remote control.
1. Take the UHF antenna off
of the receiver’s back panel
UHF Remote Antenna
input.
2. Put a 10 dB attenuator onto the
UHF Remote Antenna
input.
3. Put the UHF antenna onto the
attenuator.
S
WITCH
B
ETWEEN
TV
AND
D
EVICE
V
OLUME
C
ONTROL
If you set up the remote to control a television, the
Mute
and
Volume
buttons control the TV volume, in most modes. But, if you use the
Aux
mode to control a tuner or amplifier and the device has a volume
setting, you can set up the remote to control the device’s volume
instead of the TV volume.
For what to do, please see the next page.
text_dishpvr.fm Page 8 Thursday, July 12, 2001 10:02 AM
