Receiver Customization
59
Operating Other Devices
3
On the DISH remote, press and hold the Mode button you want to use for the device until
all the Mode buttons light up (approximately three seconds), and then release it. The
selected Mode button flashes continuously.
4
To start learning commands for this mode, select one of the following choices:
•
If you have found a code for the device and programmed it into the remote,
press and
release
RECALL (the Mode light goes off when RECALL is pressed and comes on
when released), then
hold
the RECORD button until the Mode button is lit again
(about three seconds). The Mode button remains lit while learning.
•
If the device code has not been programmed for that device or if you are unable to find
a code,
press and hold
the RECORD button until the Mode button is lit (about three
seconds). The Mode button remains lit while learning.
5
On the DISH remote,
press and release
the button you want the DISH remote to learn
from the original device’s remote. The Mode light goes off and comes back on.
6
On the original device’s remote control,
press and hold
the button you want learned until
the Mode light goes out and comes back on. You may need to press and hold the button
on the original remote several times before the DISH remote learns the command.
•
If the DISH remote learns the command, the Mode light flashes off and then back on.
•
If the Mode light flashes three times and remains lit, the DISH remote did not learn the
command.
7
After a button has learned a command successfully, repeat step 5 and step 6 until all
commands you want have been learned.
8
Press and release
one of the Mode buttons on the DISH remote to end the learning
sequence. This saves all the commands for that mode and exits learning to return to
normal remote control operation.
To cancel learning, do not press any buttons on either remote control for at least
20 seconds. The DISH remote control times out and returns to normal operation.
Note
: If the remote control batteries are too low for learning, all the Mode buttons blink
quickly eight times. Learning ends without saving learned commands, and the remote
returns to normal operation. Change the batteries and begin learning again.
Note
: No learned commands are saved if the DISH remote control times out before
completion.
SA
T
POWER
I
MENU
GUIDE
B
R
O
W
S
E
T
H
E
M
E
S
MUTE
RECALL
SKIP
CK
PA
US
E
PLA
Y
D
VOLUME
DVR
TV
VCR
AUX
TV
PA
G
E
CANCEL
INFO
VIEW TV
SKIP
FWD
FWD
P
O
S I
T
I O
N
less than
3 inches
Summary of Contents for VQ4510
