24
Troubleshooting
No picture
S7090PVR is not plugged in or turned
on at the wall.
Check the front panel. If nothing
is illuminated then it is a power
issue - please check power
socket and plug socket.
Remote control is not
working
Your display isn’t able to display the
current Output Format.
No batteries or batteries incorrectly
inserted.
Insert the supplied 2x AAA batteries
as shown on page 6.
Batteries are flat.
Insert fresh batteries as shown on
page 6.
Infrared reciever on S7090PVR is
obstructed.
Check that there is a clear “line of
sight” from the remote to the sensor
on the front panel.
Picture is distorted -
too wide or narrow
Wrong TV shape is set.
Go to Main Menu/Installation/System
Setting/Aspect Ratio, make sure it is
set to match the shape of your display.
Please make sure that Main Menu -
Installation - System Setting - HD
Resolution is set to one that
your TV will be able to display.
You can view this using the
composite output
Problem
Possible Causes
Solution
When recording 1 channel
cannot go to another
channel
No Signal to Tuner.
Fit loop cable from LNB1 Out to
LNB 2 In
No Channels loaded.
Database is Empty
No Signal In.
Dish Cable not plugged into LNB in
Faulty LNB or Dish.
Have dish checked then try Main
Menu/Installation/Factory Default
and scan again.
