16(35)
User manual in Original
Dok. ref: User manual 500A-ATF-K Rev. F
DISPERATOR AB
Tel: +46 8 724 0160
E-mail: info@disperator.se
Mälarvägen 9, SE-141 71 Segeltorp, Sweden Fax: +46 8 724 6070
Web page: www.disperator.se
6.1.3.
Fixating of Disposer
The disposer must be fixed with a torque protection bar fitted to the wall or bulkhead as per the figure
below. When starting or stopping quickly (e.g. if cutlery jams the grinding unit) the torque of the
motor will cause the disposer to turn. This may move the drain pipe/water trap from its position
causing water leakage. The torque protection bar is not included in standard delivery but is available
as an option. If a torque protection bar is not suitable because of the distance to the bulkhead, weld
the feet directly to the floor plate. Also torque protection clamps for floor plate mounting are
available as option from Disperator, which facilitates service work as no welds around the legs need to
be cut loose.
6.1.4.
Protective Lid Connected to a Safety Interlock Switch
Below mentioned numbers in brackets refer to the picture above.
1.
Mesure, mark and drill two holes (diameter 16,5mm) for the spindle of the lid on opposite sides of
the sink/dishwashing line. Make sure that the protective lid (1) is centered above the disposer
inlet. See picture below for measurements.
Torque protection bar
