28(35)
User manual in Original
Dok. ref: User manual 500A-ATF-K Rev. F
DISPERATOR AB
Tel: +46 8 724 0160
E-mail: info@disperator.se
Mälarvägen 9, SE-141 71 Segeltorp, Sweden Fax: +46 8 724 6070
Web page: www.disperator.se
14.
Remove the carrier (-18) carefully. If it is stuck, usethe supplied carrier removal screw, on the top
of the carrier and screw it down. This will remove the carrier from the motor axle. If needed, use
the rotary shredder (-02) as a handle to prevent the motor axle from rotating.
15.
When changing the motor (-14), make sure that the new motor has the same classification and
quality as the original. The motor must have holes to allow for ventilation and drainage of water
condensation (see picture below and original motor). If drilling holes in the motor, it is important
to drill at the right angle, so that there is no damage to the motor or any of its parts. All
replacement motors delivered by Disperator have premade drainage holes.
