27(33)
User manual in Original
Dok. ref: User manual 500A-BS Rev. C
DISPERATOR AB
Tel: +46 8 724 0160
E-mail: info@disperator.se
Mälarvägen 9, SE-141 71 Segeltorp, Sweden Fax: +46 8 724 6070
Web page: www.disperator.se
10.5.
Assembly of Disposer
1.
Clean all components carefully. Wipe the surface of the motor (-14) and the shaft. Make sure that
there is no dust or grease residue.
2.
Make sure that the key (-14/03) is in the correct possition. Apply a thin layer of Disperator special
grease (-04) on the motor shaft.
3.
Wipe the carrier (-18) clean of recidue on the inside and outside.
4.
Mark the depth of the hole in the carrier (-18) onto the motor axle. The depth is 38mm for models
510A - 515A, 48mm for model 520A and 58mm for models 530A - 575A. Carefully press the carrier
(-18) onto the motor axle all the way down to the mark. If hand power is not sufficient, use the
axle screw (-07) as a mounting tool. Use the rotary shredder (-03) as a handle if needed.
5.
Wipe the inside of the hole on the end shield (-13) clean of residue.
6.
Place the washer (-03/00) in the end shield (13) with the flange facing towards the motor.
7.
Grease the sealing face of end-shield (-13) with special grease (-04).
8.
To avoid damageing the seals (-03/02, 2pcs) press each seal one at the time into position useing a
tool that has the same outer diameter as these seals. The seals shall be placed with the groove
and stainless spring upwards towards the washer (-03/00).
9.
The seals are fixated by fitting the locking ring (-03/03) into the groove in the end shield (-13). Tap
on this ring to ensure that it is seated properly in the groove in the end shield.
10.
Grease the axle seals (-03/02) and pack the space between the two seals with special grease (-04.
Use a soft brush.
11.
Apply a thin layer of special grease (-04) on the carrier (-18). Use a soft brush.
12.
Fit the end shield (-13) with the outlet facing in the same direction as the connection box on the
motor. Care should be taken not to damage the lips of the axle seals. Tighten all four screws (-23).
The torque should be 50Nm for models 510A-520A and 81Nm for models 530A-575A.
13.
Grease the V-ring seal (-03/01) and washer (-03/00) using special grease (-04). Fit the V-ring seal
over the carrier (-18) with the seal lip against the washer (-03/00).
14.
Fix the carrier key (-10) with grease.
15.
Wipe the axle hole in the rotay shredder (-02) clean. Also make sure that the mateing surfaces on
the end shield (-13) and the stationary shredder (-01) are clean.
16.
Fit the rotary shredder (-02) on the carrier (-18).
17.
Wipe the carrier (-18) clean from excess grease.
18.
Apply a layer of rubber sealing compound (-09) over the joint between shredder and carrier axle.
Make sure that the thread is free from sealing compound.
19.
Fit the washer (-06) and tighten the axle screw (-07). The torque should be 9.3Nm for models
510A-515A, 22Nm for model 520A and 44Nm for models 530A-575A.
