28(33)
User manual in Original
Dok. ref: User manual 500A-BS Rev. C
DISPERATOR AB
Tel: +46 8 724 0160
E-mail: info@disperator.se
Mälarvägen 9, SE-141 71 Segeltorp, Sweden Fax: +46 8 724 6070
Web page: www.disperator.se
20.
Apply a thin continuous string of rubber sealing compound (-09) in the seat of the end shield (-13).
21.
Carefully position the stationary shredder (-01) with the large tooth at the outlet of the
end shield (-13).
22.
Tap the stationary shredder (-01) with a plastic hammer to fix it in the end shield (-13) and make
sure that the stationaty shredder is in the correct place.
23.
Secure the stationary shredder to the end shield by hammering 6 punch marks around the joint
between these two articles.
24.
Put the rubber seal (-05) on the stationary shredder (-01). Make sure that it is centered.
25.
Wipe the surface of the hood (-16) that faces the rubber seal clean.
26.
Carefully fit the hood (-16) so that its outside arrow mark is positioned centrally to the waste
outlet on the end shield (-13).
27.
Secure the hood with 2 nuts (-25) and 2 washers (-25/1) on the two non hilighted positions (see
section 10.4. step 6). The torque should be 9,5Nm for models 510A-520A and 21Nm for models
530A-575A.
28.
Turn the disposer upside down.
29.
Secure the strap (-17) using the two remaining hexagonal nuts (-25) and washers (-25/1). The
torque should be 9,5Nm for models 510A-520A and 21Nm for models 530A-575A.
Outside arrow mark on hood
