29(33)
User manual in Original
Dok. ref: User manual 500A-BS Rev. C
DISPERATOR AB
Tel: +46 8 724 0160
E-mail: info@disperator.se
Mälarvägen 9, SE-141 71 Segeltorp, Sweden Fax: +46 8 724 6070
Web page: www.disperator.se
30.
Pull the motor cable trough the cable gland of the housing (-15).
31.
Make sure that the folded lugs on the upper rim of the housing are placed correctly inside
the hood.
32.
Secure the housing with two screws and washers (-26) on the bottom.
33.
Turn the disposer to an upright position. Using plier pull the s
eal for stationary shredder (-05) to verify
that it is properly fixated.
34.
The disposer is now ready to be refitted, use a trolley as support. For alternative ways to hoist the
disposer see section 6.1.2.
35.
Make sure that the seal for the hood (-08) is placed correctly before you move the disposer into
place. Use 6pcs of screws and nuts (-22). See section 6.1.2 for the correct procedure.
36.
Reconnect drain piping according to section 6.3. Make sure that the disposer is securely fixated so
it can withstand the start torque and the tourqe which occurs if the disposer ever gets stuck
(see section 6.1.3). Connect the electricity according to section 6.4.
37.
Start up the disposer according to the startup procedure described in section 6.5.
10.6.
Service and Maintenance Intervalls
Maintenance
Interval
Comments
Cleaning of disposer
Daily
See section 9.2. in this
user manual
Check line strainer
First time after a month
then when needed
See section 9.3.2. in this
user manual
Check mounting assembly
First time after a month
then when needed
See section 10.3. in this
user manual
Preventive maintenance
After approx. 3000 hours
of use or latest after 5
years
Service pack 1
Replacement of parts due to wear
After approx. 9000 hours
of use
Service pack 2
All other parts
When needed
