User manual in Original
Doc. ref: 500A_MB_am_en_210602
DISPERATOR AB
Tel: 08-724 0160
E-mail: info@disperator.se
Mälarvägen 9, 141 71 Segeltorp
We page: www.disperator.se
18 / 41
6.1.3. Changing the outlet direction of the machine
Unless otherwise requested in your order, the cabinet is delivered with the disposer’s outlet on
the back of the cabinet. Regarding the cabinet’s location in relation to the drain connection in
the floor / floor, it is possible to turn the disposer with outlet 90⁰ to the left or to the right. If
necessary, this is done as follows
Open the door, if necessary, remove it.
To avoid injuries when unscrewing the disposer from the connecting flange of the hopper, the
bottom of the disposer must be supported by a lifting trolley.
Unscrew the six nuts that hold the disposer against the connecting flange of the hopper. Unscrew
the hood 4 nuts with washers and turn it one step clockwise, tighten the hood. For models
510A-520A pull with torque 9.5 Nm and for models 530A-575A pull with 21 Nm. Then turn the
disposer with the outlet to the desired left or right position.
Check that the seal between the disposer and the hopper connection flange is correct before
screwing the grinder back on. Tighten the six nuts evenly.
Punch a hole in the side panel to enable the outlet pipe to be connected to the disposer in the
new position. For models with a motor power below 2.5 kW, the hole diameter should be 63-65
mm. For models with a motor power of 2.5 kW or more, the hole diameter should be 73-76 mm.
There are two small marks on the left and right sides of the outer casing.
Use the upper mark for models with a motor power below 2.5 kW or the lower mark for models
with a motor power of 2.5 kW or more, to center the position of the new hole.
The original hole for the drain pipe should be covered with a stainless steel plate that is screwed
to the back. This plate can be delivered as an option by Disperator AB.
Summary of Contents for EXCELLENT 500A-MB Series
Page 2: ......
