disperator EXCELLENT 550A-GKF Series, User Manual

User Manual in Original

Dok. ref: 550A_GKF_am_sv_210525
DISPERATOR AB

Tel: 08-724 0160   

E-mail: info@disperator.se

Mälarvägen 9, 141 71 Segeltorp   

Web page: www.disperator.se

16 / 35

8.   Driftinstruktioner

The machine is only intended for crushing pure glass!

8.2.   Daily Cleaning

DISPERATOR AB

Mälarvägen 9, 141 71 Segeltorp

Tel: 08-724 0160

info@disperator.se, www.disperator.se

Doc. ref: 

Opera� ng Instruc� on 

550A-GKen_210409

OPERATING INSTRUCTION

FOR GLASS CRUSHER

Disposer Control Panel

Daily Cleaning of Disposer

1.  Attach a collection bag of strong 

plastics to the machine outlet. 

Use the pre-mounted elastic cord, 

and make sure the bag fi ts tightly 

against the seals on the outlet.

2.  Press the green button (1) - the 

glass crusher starts. 

3.  Depending on size, feed the 

bottles one by one into the inlet 

tube at every 5 - 10 sec.

4.  When the crushing is completed 

only the machine’s idle sound is 

heard.

5.  Press the red button (0) - the 

glass crusher stops within 5 sec.

1.  Use protective gloves.

2.  Remove the bag with crushed 

glass, and instead place a bucket 

under the  machine outlet.

3.  Start glass crusher with green 

button (1).

4.  Insert a hose in the inlet tube 

opening, and rinse with warm 

water to remove beverage 

residue and prevent  bad odors.

5.  If needed, empty the bucket and 

repeat item 4 above.

6.  Press the red button (0) - the 

glass crusher stops within 5 sec.

7.  Use the main electrical safety 

breaker (placed on the wall/

bulkhead) to disconnect 

electrical supply. Lock the 

breaker with a padlock if you 

need to leave the machine 

temporarily before item 11 below 

is completed.

8.  Loosen the knob and lift off the 

inlet tube from the machine 

front panel. Make sure that the 

area around the O-ring seal 

on the tube, and also the area 

around the front panel opening 

to the interlock switch, is clean 

and free from crushed glass.

9.  Remove any foreign objects 

(e.g. bottle caps, plastics etc.) 

that may remain in the glass 

crushing unit of the machine.

10.  When the inlet tube is refi ted 

and fi xed with the knob on the 

front panel, also check that the 

O-ring seal is intact and that the 

key on the tube easily slides into 

the interlock switch.

11.  See section 9.3.2 of the user 

manual, and check that the 

machine´s automatic function for 

collecting glass dust works.

12.  Use the main electrical safety 

breaker to connect the electrical 

supply

 The glass crusher is intended for crushing pure glass only

•  What can be crushed: wine, beer, champagne bottles, jars and containers of glass

•  What cannot be crushed: materials that can cause explosion, spread infection or 

chemical pollution (e.g. lamps containing mercury)

•  Non-crushable materials: metal, stone, wood, plastic, rubber, strings and the like 

•  What can be crushed: wine, beer, champagne bottles, jars and containers of 

glass

•  What cannot be crushed: materials that can cause explosion, spread infection or 

chemical pollution (e.g. lamps containing mercury)

•  Non-crushable materials: metal, stone, wood, plastic, rubber, strings and the like 

8.1.   Start and Stop