MKT.183.5 | DISPLAX
TM
OQTOPUS USER GUIDE
11
CONTROLLER LCD AND PC INSTALLATION
DISPLAX OQTOPUS COMES WITH LCD AND PC INSTALLED UNLESS ASKED
OTHERWISE. IF YOU ORDERED DISPLAX OQTOPUS WITH LCD AND PC ASIDE YOU
MUST READ THIS CHAPTER.
SEPARATE THE METALLIC GRID AND THE GLASS FROM THE TABLE
Unscrew the 10 screws H that connect B to A.
Take the metallic grid out very carefully. The glass will still be attached to the metallic grid.
Always hold by the edges of the glass.
Put B in a place safe and clean, with the metallic grid facing down. The glass surface should
cable.
PREPARE THE CABLES
You will need to connect several cables: USB (A/mini) (Ka); USB (Lb); HDMI (N).
Some cables are attached in the tray using P, depending on whether PC and/or LCD were
shipped or not. Loose the looped ends by releasing them from the last P if you need. There
are some spare cable clips in case you need.
INSTALL THE PCB CONTROLLER
K needs to be attached to the small drawer of A using Velcro already applied both to K and
A. Then, connect K to the ribbon cable of B. To do so, carefully lift the clamping clip (grey bar)
as shown on the following picture, taking care not to over extend the clamping clip.
Insert the ribbon cables into position. Once the ribbon cable is inside the connector, gently
press down the clamp to lock.
05
Open position
