2TCASE - Display Case
*** 2 People are needed for assembly***
Step 9: Connect all wires on top of the case.
After completing the wire assembly,
place the top cover over the wires. Make
sure all wires are pushed down & in so
that the top over is properly seated on
the unit.
Step 10: Using (2) people, carefully pick up the
top case assembly. The (4) male
connector rods on the bottom of the
top case assembly should fully sit inside
the extrusion on the bottom case
assembly.
Very Important: The top case assembly must be picked up by
the front & back panels. The side panels of the top case
assembly are not secured & will slide out of the unit if not
picked up properly.Highly recommended to see our
assembly video online under the SKU: 2TCASESLVS &
2TCASESBLKL
Step 11: With all doors open on both the
top & bottom cases, proceed to
connect the wiring from the
bottom case to the wiring on
the top case.
Step 12: Connect all side bulbs
Step 13: Insert rubber pieces into the
metal shelf holders
Step 14: Place all shelves in (frosted shelf
goes in base of top unit)
Step 15: Plug in
Page 2
Frosted Shelf
