ATTENTION
:
Unpack the unit and confirm all hardware are present. If any hardware required is missing, or if
you have any questions regarding our products, please contact D2G customer service
at 844-221-3388.
Assemble the unit on a carpeted floor or on a soft surface work area to avoid any scratch. A phillips screw driver
is needed. 2 people recommended.
1. Insert 2 cam posts (H2) into holes in Panel E. Tighten only
until snug. Fit cam holes in the edge of Panel F over the cam
posts. Insert 2 cam locks (H1) into cam lock holes on Panel F,
use a phillips screw driver to turn cam locks clockwise to
secure cam posts.
DO NOT over-tighten.
2. Insert 4 cam posts into holes in Panel D as shown below.
Attach Panel C and assembled Panel E to Panel D by inserting
cam posts into the cam lock holes. Insert 2 cam locks into cam
lock holes on Panel E, turn cam locks clockwise with a phillips
screw driver to secure cam posts.
Fix Panel C the same way.
H1
Cam Lock
H2
Cam Post
E
How to join 2 boards with CAM lock:
(a) Insert cam post into flat surface of a board. Fit the hole in the
edge of the joining board over the cam post.
(b) Each cam lock has an open sec�on at the back. Insert the cam
lock into the cam Be sure the opening fits the head of the cam post.
(c) Use a screw driver to turn the cam lock clockwise so it locks onto
the head of the cam post. Do not over �ghten.
(a) (b) (c)
PARTS
A Top Panel
B Side Panel
C Middle Panel
D Back Panel
E Bo�om Panel
F Toe Kick Panel
G Door Panel
1pc
2pcs
1pc
1pc
1pc
1pc
1pc
HARDWARE
H1 Cam Lock
H2 Cam Post
H3 Wood Screw
H4 Concealed Hinge
H5 Door Handle
H6 Screw
30pcs
30pcs
12pcs
2pcs
1pc
2pcs
ASSEMBLY INSTRUCTIONS
TRASH RECEPTACLE - CIRCULAR TOP OPENING
1 of 2
Rev. 20.02
