7
x
INSTALLATION
The sensor should be
fixed firmly to avoid
extreme vibrations.
Do not cover the sensor.
Avoid moving objects
and light sources in
the detection field.
Avoid highly
reflective objects in
the infrared field.
It is recommended to clean
the optical parts at least once
a year or more if required due
to environmental conditions.
Do not use aggressive
products to clean
the optical parts.
•
The device cannot be used for purposes other than its intended use. All other uses cannot be
guaranteed by the manufacturer of the sensor.
•
The manufacturer of the door system is responsible for carrying out a risk assessment and installing the
sensor and the door system in compliance with applicable national and international regulations and
standards on door safety.
•
The manufacturer of the sensor cannot be held responsible for incorrect installations or inappropriate
adjustments of the sensor.
Only trained and
qualified personnel
may install and setup
the sensor.
The warranty is invalid if
unauthorized repairs are
made or attempted by
unauthorized personnel.
Always test the good
functioning of the
installation before
leaving the premises.
The door control unit
and the door cover
profile must be correctly
earthed.
MAINTENANCE
SAFETY
LED-SIGNAL
Motion
detection
Presence
detection
LED flashes
LED flashes
quickly
LED is off
LED flashes
x times
LED flashes
red-green
