User Manual
Safe Money automatic safe
8
3.2
FIXING INSTRUCTIONS ON THE SURFACE
NB: the fixing plate is an accessory that can be purchased separately.
FIXING INSTRUCTIONS ON THE SURFACE
It is possible to fix the automatic cash register on the floor, through the threaded holes of the feet:
(A) from
inside the case of the automatic cash register to the floor
(B)
from the support surface to the automatic cash register
Fixing plate
FOR ASSEMBLY VER. (A)
3 M6X ALLEN SCREWS (17 mm + FLAT THICKNESS) with countersunk head
1 ALLEN SCREW M8 (17mm + FLAT THICKNESS)
FOR ASSEMBLY (B)
4 ALLEN SCREWS M8 (17mm + FLAT THICKNESS)
Screws
FIXING OF THE AUTOMATIC CASH REGISTER FROM INSIDE THE CASE TO THE FLOOR
REAR
FRONT
LEFT FRONT SIDE
REFERENCE ARROW
TOP VIEW
Surface
1) Place the plate on the surface, where you want to install the
automatic cash register.
4) Unhook the Smart money module, to reach the hole in the
base (D)
6) Insert the fourth M8 screw into hole C, from the plate
towards the case, as shown in fig.4
Insert the safety
lock to keep the
door open.
2) Take the holes on the plate (fig.2) as a reference with a pointed
object/marker and drill with a 7mm drill bit for points A, B, D and 9
mm for point C.
3) Remove the 4 feet present under the base as shown in fig.3
5) Place the plate under the surface and screw in with 3 M6
countersunk head screws, in holes A, B, D
5) Proceed to re-insert the Smart Money module inside the
case and close the automatic cash register
The height of the screws depends on the thickness of
the surface Min. 17mm + surface thickness
