www.diverite.com
July 2017 © Lamartek, Inc. dba Dive Rite
18
•
Always rinse the light and hand mount thoroughly in fresh water after
use in saltwater.
•
The canister lid can be removed, rotated 180 degrees and reinstalled
with the power plugs oriented into the blank holes in the battery lid for
storage and transportation. This prevents accidental activation of the
light. Always switch the lid to the travel position after every dive to
prevent accidental turn on. The light head will get extremely hot if
turned on out of the water and can cause damage to other equipment
and injury to the user.
•
Store the light in a cool and dry environment.
•
Always charge the batteries following the instructions provided.
•
The two head O-rings should be kept clean and lubricated with a light
coating of silicone grease and replaced annually. See your Authorized
Dive Rite dealer for replacement O-rings. (Dive Rite P/N RP9992-RED)
•
The battery canister lid O-ring should NOT be greased. It should be kept
clean and wiped down between dives. This O-ring should also be
replaced annually. (Dive Rite P/N LT6015-RED)
Dealing With a Flooded Light
If your light floods, there are a few things you need to do:
•
Do not continue to use the light.
•
Turn the light off and disconnect the light head from the battery pack
as soon as possible. If there is any water in the battery canister, drain
the water and allow it to dry. DO NOT REINSTALL THE CANISTER LID.
Storing a damaged or flooded battery inside of a sealed canister can
lead to an explosion.
