VersaGateway User’s Manual
Document #: 2015006.1.pdf
PAGE 14 of 44
Divelbiss Corporation • 9778 Mt. Gilead Road • Fredericktown, Ohio 43019 • 1-800-245-2327 • www.divelbiss.com
Device Features
CAN PORT 0 CONNECTIONS
CAN port 0 is connected using the terminal block labeled CAN0 (Item 7). Refer to Figure 2-3 for an example CAN bus connected to
CAN 0 and termination locations.
CAN PORT 0 TERMINATION
CAN port 0 requires the use of terminating resistors. The VersaGateway devices have an on-board terminating resistor that may be
enabled or disabled based on the system layout needs. Only the ends of the CAN network should be terminated using the terminat
-
ing resistors. The terminator is configured using an on-board configuration Jumper - JMP14. Refer to Figure 1-5 for general location
of the JMP14 configuration jumper. Refer to Figure 2-2 for JMP 14 Pin 1 location.
CAN PORT 0 TERMINATOR JUMPER
Jumper ID
Shunt Installation
Description
JMP14
Shunt installed Pins 1-2
CAN Port 0 Terminating Resistor Disabled
Shunt installed Pins 2-3
CAN Port 0 Terminating Resistor Enabled
CAN 0 Port Terminal Block Pin-Out
PIN ID
CONNECTION
H
CAN Port 0 HI connection
L
CAN Port 0 LO connection
Earth / Chasis Ground
PIN 1
Figure 2-2 - JMP14 Pin 1 Location
PIN 1
CAN
DEVICE
CANHI
CANLO
SHD
SHD
CANLO
CANHI
CAN
DEVICE
CAN
DEVICE
CANHI
CANLO
SHD
CANLO
CANHI
VersaGateway
USE SHIELDED CABLE
ENABLE
TERMINATOR
ENABLE
TERMINATOR
Figure 2-3- CAN Connections & Bus Terminating