10
Removing and cleaning the suction nozzle
Notice:
Only cleaned and intact blades ensure optimal suc
-
tion results!
Empty and clean the recovery tank and fresh
water tank
Cleaning the recovery tank and fresh water tank
Caution:
Clogged suction filters may impair the suction per
-
formance.
Cleaning the fresh water tank filter
Caution:
Clean the fresh water tank filter after the end of op
-
eration.
Clogged filters can inhibit the supply of detergents and
thus lead to surface damage.
Notice:
The filter is lower than the drain hole of the tank. A
rest amount of cleaning solution will run out only
when the filter is removed.
Removing and cleaning the brush
Notice:
Clean the brush whenever cleaning work is com
-
pleted.
Cleaning the machine
Caution:
Never clean the machine with a high-pressure
cleaner or water jet.
Water ingress in the machine may cause considerable
damage to the mechanical or electrical parts.
• Pull the suction hose from the connector.
• Lift the suction nozzle with your foot.
• Compress the lock springs. The suc
-
tion nozzle is released and can be re
-
moved from the squeegee holder.
• Clean the suction nozzle under running water using a
brush.
• Remove the drain water hose (red) from the holder.
• Put the drain hose into the drainage.
• Press the crushing point (1) of the drain hose.
• Pull the lid off the drain hose and
drain the recovery tank.
• Proceed in the same way for draining the fresh water tank.
For that purpose, remove the cleaning solution drain hose
(glue) from the holder.
• Open the tank cover until the support
engages in the tank wall.
• Rinse the recovery tank and the fresh water tank thorough
-
ly with clean water.
• Remove the dirt sieve (yellow), emp
-
ty it and thoroughly rinse it under run
-
ning water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
1
1
• Check the float to make sure it is fully
functional and repair any fault
• After you have finished emptying the tanks, screw the red
and blue cover back on and hang the hose on the holder.
• Reassemble the dirt sieve (yellow) and the suction filter.
• Put the drain hoses back into the holder.
• The machine must be switched off.
• Unscrew the fresh water tank filter
and remove it.
• Rinse the filter thoroughly with clean
water.
• Put the filter back and twist it closed.
• The machine must be switched off.
• Push the tool ejector briefly but firmly
with your foot.
• Remove the brushes and clean them under running water.
• Wipe the machine with a moist cloth.
