7
Notice:
Connect the battery with the machine at the battery
disconnection socket.
Prior to commissioning
Relocation drive
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Caution:
Do not use brushes which have reached their wear
limit. The wear limit is indicated by the length of the
red bristle. Do not use worn or contaminated pads.
Use original TASKI brushes only.
Failure to observe these instructions may result in inad
-
equate cleaning results or even floor damage.
Notice:
When the brush is down, gently moving the ma
-
chine back and forth can make the clutch easier to
engage.
Suction nozzle assembly
Filling the fresh water tank
Caution:
Max. permissible water temperature 60 °C/140 °F.
- Diversey recommends using cold water, as hot water
will adjust to the ground temperature as soon as it
comes into contact with the ground. Thus there are no
advantages to using hot water.
• Switch on the machine (key switch).
The display lights up briefly.
The battery level indicator notifies
you that the machine is ready for op
-
eration. (In case of malfunctions,
please see page 13).
• Take the driving handle and arrange
the height of the driving switches in
such a way that you can work easily
with them.
• By gently pushing the driving switch
into the direction of movement, the
machine is set into motion. If you let
go of the driving switch, the machine
will stop.
• Position the tools under the tool unit.
• Switch the machine on.
The indicator elements lights up briefly.
• Unlock the foot pedal and lower the
tool slowly.
While lowering the brush drive will
slowly start to pulse. In this way the
tool is centered and engaged.
The brush drive display lights up
• The machine must be switched off (main switch).
• Position the suction nozzle (2) below
the squeegee holder (1).
• Press the foot pedal down until the
squeegee holder engages.
• Attach the suction hose to the con
-
nector.
• The machine must be switched off (main switch).
• Put your hand into the opening be
-
tween tank cover and tank.
Palms upwards.
• Open the tank cover until the support engages in the tank
wall.
• Remove the dosage aid.
• Fill the fresh water tank with water.
Maximum filling level (page 4).
• Tip the tank cover back into its original position and press
it down until it locks.
1
1
2
2
