DIVUS HEARTBEAT user manual .
48
Field
Values or example
Explanation
Incoming interface
All,
DIVUS Secure Intranet,
Residential Intercom,
Home Network
Choose which of the three network ports of the
MANAGER is targeted
Protocol
TCP
UDP
Choose the protocol
Incoming port
50000
(port of the HEARTBEAT)
Choose a free port
Source IP address/range
192.168.1.0/24
Choose a single address or a range, or allow all
the devices on the network (see incoming
interface)
Destination IP address
192.168.1.110
Insert the address of the target device
Destination port
80
If it is the web interface, use 80. Otherwise, refer
Enabled
checked/unchecked
Use the checkbox to apply or disable the rule
temporarily.
6.7
HOW TO SETUP A DEVICE FOR REMOTE VOIP ACCESS
Please note that
this functionality anyway, please follow these steps:
1.
Add a port forwarding rule to your internet router: use any external port -
use 5060 and of course never use the ones where known services run like 80,
443 etc. This should be forwarded to port 5060 of your DIVUS HEARTBEAT. In
this case use the IP address 192.168.69.1 - or if you changed that, the new
one - as destination. Use the chosen port in your client configuration(s).
2.
Make sure the devices used for the remote access use the correct settings
for the sip parameters
•
nat=force_rport,comedia
•
qualify=20000
•
directmedia=no
•
localnet=192.168.69.0/24,192.168.0.0/24
•
externip/externhost=(public IP address/domain name)
If these settings are all correct, the voice will travel over the SIP channel. Therefore, no additional port forwardings
for RTP are needed. If you should still have issues, try adding a port forwarding for RTP on a range of 100 ports
