Dixie Narco DNCB 501E Technical Manual Download

Page: 5 / 85

INSTALLATION & SETUP

The Dixie-Narco Pepsi-Cola High Visibility Vender is
designed utilizing the latest technology.

UNPACKING THE VENDERS

Remove the stretch wrap and top cover from the
vender. Product cards are installed in the select
buttons.

DO NOT STORE THE VENDER
OUTSIDE WITH THE STRETCH
WRAP ON. THIS COULD CAUSE
THE STRETCH WRAP TO BOND
TO THE VENDER’S SURFACE,
WHICH COULD DAMAGE THE
FINISH.

Remove the shipping boards from the bottom of the
vender. The shipping boards are attached by the
leveling legs. To avoid unnecessary damage to the
leveling legs or base, remove the shipping boards by
using a 1½ ” “socket type” wre

nch to unscrew the

leveling legs. Be sure to replace the legs after
removing the shipping boards.

ELECTRIC POWER NEEDED

Refer to the cabinet serial number plate to determine
the proper voltage and frequency the machine
requires (domestically this requirement is 115 Volts,
60 Hertz). The cabinet serial plate also indicates the
Ampere rating of the vender. Single phase,
alternating current is required. The vender must be
plugged into a properly rated circuit with its own
circuit protection (fuse/circuit breaker).

DO NOT USE AN EXTENSION CORD.

GROUND THE VENDER

The vender is equipped with a three-wire power
supply cord and MUST be plugged in a properly
grounded outlet.

DO NOT REMOVE THE GROUND PIN OR IN ANY
WAY BYPASS THE GROUND OF THE VENDER.

If the outlet will not accept the power cord plug,
contact an electrician to install a proper AC outlet.

FAILURE TO COMPLY WITH
THESE INSTRUCTIONS MAY
SUBJECT THE USER TO THE RISK
OF INJURY OR ELECTRICAL
SHOCK WHICH CAN BE SERIOUS
OR FATAL.

PEPSI ELECTRONIC DOOR LOCK

The electronic lock provided in the vender consists
of a door mounted, motor driven bayonet (shaft)
system, a cabinet mounted nut receptacle switch
system, an infrared controlled CPU, and a remote
control key (FOB). The design is modular and
allows for easy field service.

The electronic remote key (FOB) features a rolling
code system which cannot be decoded if it is lost or
stolen. After the vender has been unlocked, a new
key can be programmed into it any number of times.
If a key is lost or stolen, it is recommended you
change the lock code in the field as soon as
possible. Changing the lock code requires a new
key and pressing the LEARN button inside the
vender. The lock does not need to be changed for
re-keying.

Important:

For security reasons all Electronic

Door Lock Venders are shipped less
keys. Customers will need to
contact the Electronic Door Lock
manufacturer to order keys.

A power bypass connector, located in the product
delivery port, allows auxiliary power to be applied via
a battery pack to the electronic lock in the event that
power is not available or there has been a failure of
the internal power supply. In the event of an
emergency, battery power is applied to the
connector and the door can be opened and closed
using the FOB.

The electronics uses an infrared transmission
system, which functions similar to a television
remote control. The transmission signal is line-of-
sight, which requires you to aim the remote at a
specific place at close range to prevent the
accidental opening of several venders at the same
time.