CONTROLS
21
Seat Adjustment Lever
The seat can be adjusted lengthways. When making
adjustments, the lever under the front edge of the
seat is moved to the left (as seen by the driver in the
seat), after which the seat can be moved backward or
forward.
8058-221
Lengthways adjustment
Hour Meter
The hour meter displays the total operating time with
the blade activated.
The display on the hour meter will turn on the oil can
icon after every fifty hours of use and will stay on
for two hours or until the meter is manually reset. To
manually reset the timer, turn the ignition key to the
run position and then engage and disengage the
blade switch five times at one second intervals.
8050-081
Hour meter
Cutting Height Adjuster
The deck cutting height is obtained by pressing the
foot pedal forward to lift the deck. To lower the deck,
apply pressure to the top side of the foot pedal and
allow it to pivot while the lift arm rotates to the rear of
the unit. To stop in the desired cutting position, rotate
the foot pedal down into the notch in the height plate.
The cutting height range is from 1½" (38mm) to 4½"
(114mm) in ¼ (6mm) increments. The heights are
measured from the ground up to the blade tip with the
engine not running.
8066-027
The mower deck’s lifting pedal
IMPORTANT INFORMATION
To obtain an even cutting height, it is
important that the air pressure is 15 psi in all
tires.
Summary of Contents for 966690603
Page 51: ...51 SCHEMATIC 8053 002...
Page 60: ......
