MAINTENANCE
40
1
2
3
Pump Belt
The belts are not adjustable. Replace belts if they
begin to slip from wear.
Replacing Pump Belt
Park the mower on a level surface. Engage the
parking brake.
Belt Removal
From the top side of the deck:
1. Remove the deck belt (see
Deck Belt Removal
in
this section of the manual).
2. Tilt seat forward to access fan covers. Remove
both fan covers.
8058-060
1. Electric clutch
2. Idler arm release placement
3. Clutch stop
Pump belt removal
V-belts
Check every 100 hours of operation. Check for severe
cracking and large nicks.
NOTE: The belt will show some small cracks in normal
operation.
From the underside of the mower:
3. Remove clutch stop to access the belt.
4. With a ½" breaker bar and using the square
opening in the pump idler arm, shift the arm to
create slack in the belt.
5. With the idler arm in the slack position, slip a
screwdriver, clevis pin or similar into the
3
/
8
" hole
in the plate that sits between the two fan covers.
This will keep the idler in the extended position
and allow removal of the breaker bar.
6. Remove belt from the engine and pump pulleys
over the top of the fans.
Belt Installation
If the pump is not locked in the extended position,
repeat Steps 4 and 5 from the above instructions.
1. Slip the belt over the fans and route it between the
idler pulleys.
2. Place the belt over the right and left idler pulleys.
3. Place the belt on the engine pulley.
4. Use the breaker bar to hold the tension off the belt
while removing the implement used as a brace in
the plate.
5. Replace and secure clutch stop.
6. Reinstall the fan shields.
7. Reinstall the deck belt. (See Deck Belt Installation
in this section of the manual).
8058-064
Remove fan covers
Summary of Contents for 966690603
Page 51: ...51 SCHEMATIC 8053 002...
Page 60: ......
