22
ContRols
Fuel Shut Off Valve
The fuel shut off valve is located at the left rear of the
seat. The valve is off when the handle tab is turned
perpendicular to the fuel line.
8011-419
Fuel shut off valve in the CLOSED position
Cutting Height Adjuster
To set the desired deck cutting height, press the
release button and move the lever forward to the
preset height pin and release the button. See
Before
Starting
in the
Operation
section to change the
cutting height. The cutting height range is from 38 mm
to 102 mm in 13 mm increments. The heights are
measured from the ground up to the blade tip with the
engine not running.
8058-185
The mower deck’s lifting lever
IMPORTANT INFORMATION
To obtain an even cutting height, it is important
that the air pressure in all tires is 15 psi / 103
kPa / 1 bar.
IMPORTANT INFORMATION
Always raise the deck to the highest position
for transport.
Bypass Linkages
The levers are located on each side of the rear of the
unit below the rear engine plate. The bypass linkage
is used when manually pushing or pulling the unit.
See
Moving Machine By Hand
in the
Operation
section.
8058-0147
Left side bypass linkage
WARNING!
Bypass linkages are located close to the
muffler. To prevent burns, the engine
should be shut off and allowed to cool
before the bypass linkage levers are
handled.
Summary of Contents for 966698603
Page 50: ...50 schematics...
Page 58: ...58 SERVICE JOURNAL Action Date mtr reading stamp sign...
Page 59: ......
Page 60: ......
