CONTROLS
21
MOWER DECK CUT HEIGHT LIFT LEVER
• Located to the right and front of the
operator.
• Controls the cutting height.
• 17 positions of adjustment
• Depress trigger and move
lever forward to lower deck.
• Pull lever back to raise deck.
• Set desired cut height with
pin.
• Use foot pedal to assist with
raising and lowering deck.
NOTE:
Always use high position for transport.
The two holes at the front of the quadrant are for 1½" (38mm)
and 1¾"(44mm) cut heights.
The four holes along the bottom of the quadrant are for one
inch cut height increments— 2" (51mm) to 5" (125mm).
The second row of holes from the bottom are for an additional
¼" (6mm) of cut height over its mating one inch increment —
2¼" (57 mm) to 5¼" (133mm).
The third row of holes from the bottom are for an additional ½"
(12mm) of cut height over its mating one
inch increment —2½" (63mm) to 5½"
(140mm).
The remaining three holes
are for an additional ¾"
(19mm) of cut height
over their
mating one
inch
increments —
2¾" (70mm)
to 4¾" (120mm).
—
Fig. 4
—
Foot Pedal
Each hole provides
a different cut
height adjustment
Pin
Trigger
¾"
(19mm)
½" (12mm)
¼" (6mm)
1¾" (44mm)
1½" (38mm)
2" (51mm)
5" (125mm)
3" (76mm)
4" (102mm)
—
Fig. 5
—
Summary of Contents for 968999564
Page 51: ......
