CONTROLS
21
MOWER DECK CUT HEIGHT LIFT LEVER:
•
Located to the right and front of the operator.
•
Controls the cutting height.
•
17 positions of adjustment
•
Depress trigger and move lever
forward to lower deck.
•
Pull lever back to raise deck.
•
Set desired cut height with pin.
•
Use foot pedal to assist with
raising and lowering deck.
Note: Always use high position
for transport.
The two holes at the front of the quadrant are for 1-1/2” and 1-3/4”
cut heights.
The four holes along the bottom of the quadrant are for one inch
cut height increments (2” to 5”).
The second row of holes from the bottom are for an additional 1/4”
of cut height over its mating one inch increment (2-1/4” to 5-1/4”).
The third row of holes from the bottom are for an additional 1/2” of
cut height over its mating one inch increment (2-1/2” to 5-1/2”).
The remaining three holes are for an additional 3/4” of cut height
over their mating one inch increments (2-3/4” to 4-3/4”).
