1
2
2
maINTeNaNCe
45
Adjusting the Mower Deck
Leveling deck
Adjust the deck while the mower is on a level
surface. Make sure the tires are inflated to the correct
pressure. See
Technical Data
under
Transmission
.
If tires are under or over inflated, the deck cannot be
properly adjusted.
Four slots control the height and pitch of the mower
deck. the deck should be adjusted slightly higher in
the rear.
nOte: to insure accuracy of leveling procedure,
mower deck drive belt must be installed prior to
leveling deck.
1. Wear heavy gloves. turn each outer blade tip
to either align with the deck or in a side-to-side
manner.
2. Measure from the floor surface up to the bottom
of the blade tip on the discharge side of the
mower deck. Retain this measurement. Move to
the opposite side, check that measurement is
the same. If adjustment is required, loosen the
locknut and move mounting bolt up or down in
slot until both side-to-side measurements are
equal. Retain measurement.
3. turn both outer blades to align with the deck in
front-to-rear manner. Reposition rear mounting
bolts up or down until rear of mower deck is
positioned level to
1
/
8
" higher in the rear than the
side-to-side measurement.
4. Confirm measurements once again. Blade tips
should be level in a side-to-side manner. In the
rear, blade tips should be level to
1
/
8
" higher than
side-to-side measurement. In the front, blade
tips should be level to
1
/
8
" lower than side-to-side
measurement.
nOte: this will place the mower deck in a standard
measurement position. Additional adjustment may be
required to achieve desired cut for the type of grass
or conditions being mowed.
8050-829
1. Lift arm
2. Mounting bolts
Leveling the mower deck
8058-151
Set blades to begin measurement
Summary of Contents for DX152
