saFeTy
17
WARNING!
This mower is equipped with an
internal combustion engine and
should not be used on or near any
unimproved forested, bush covered
or grassy lands unless the engine's
system is equipped with a spark
arrester meeting applicable local or
state laws (if any).
Rollover Protection System (ROPS)
The RoPS increases the basic weight of the unit by 73
lbs/33 kg.
Do not use RoPS as a lifting, attaching or
•
anchoring point.
Do not use RoPS for wrecking or towing.
•
Do not exceed Max GVW: 2822 lbs/1283 kg.
•
Read machine’s operator manual before each
•
use.
Securely fasten the seat belt if the unit has a
•
RoPS.
Where possible, avoid operating the unit near
•
ditches, embankments and holes.
Reduce speed when turning, crossing slopes and
•
on rough, slick or muddy surfaces.
Stay off slopes too steep for safe operation.
•
Watch where you are going, especially at row
•
ends, on roads and around trees.
Do not permit others to ride.
•
operate the mower smoothly - no jerky turns,
•
starts or stops.
When mower is stopped, set brakes securely and
•
use park brake.
If any part of RoPS is damaged, the entire RoPS
•
must be replaced.
Check all bolts including seat belt for correct
•
torque before each use.
Check RoPS structure for damage before each
•
use.
RoPS bar is NoT intended for use in sub zero
•
temperatures.
WARNING!
The rollover protection system's
capabilities may be impaired by
damage if the mower is overturned
or if alteration to the ROPS occurs. If
these conditions take place, the total
structure MUST be replaced.
Spark Arrestors
A spark arrester is standard equipment on the unit
and is attached to the engine muffler. Clean the
interior screen regularly, depending on usage and
conditions.
To clean, remove the clamp securing the tail pipe.
Remove the tail pipe and slide the spark arrestor
screen out of the muffler. Clean carbon from the
screen with a soft brush or cloth.
Replace screen and reattach the tail pipe, orienting
the tail pipe either horizontally or upwards, away from
grassy surfaces.
WARNING!
The engine and the exhaust system
become very hot during operation.
There is risk for burns if touched.
Allow engine and exhaust system to
cool at least two (2) minutes before
refueling.
8011-514
Regularly clean spark arrestor screen
Summary of Contents for GRIZZLY SE 6029FX
Page 57: ...TIMER SCHEMATIC 57 WIRING DIAGRAM...
Page 70: ...70 SERVICE JOURNAL Action Date mtr reading stamp sign...
Page 71: ......
Page 72: ...P N 115 276826R1 09 21 09...
