1
3
2
lUbRICaTION
52
8065-036
1. Pump filter
2. oil reservoir
3. Drain port
Changing the hydraulic pump oil and filter
Hydraulic Drive
Fluid Change
The hydraulic drive is designed with an external
filter for ease of maintenance. To ensure constant
fluid quality levels and longer life, an oil filter change
interval of every 500 hours is recommended.
The following procedure can be performed with the
pump installed in the vehicle, and the vehicle on level
ground.
Lock the vehicle parking brake.
1.
Place an oil drain pan with a
2.
2 gallon
capacity
beneath the oil reservoir. Remove the drain
port and drain oil. Remove the oil filter from the
pump.
Do not fill above
this level
minimum fill level
Drain old oil filters of all free-flowing oil prior
to disposal. Place used oil in appropriate
containers and dispose of it in accordance
with laws in your area.
After the oil has drained, wipe the filter base
3.
surface off and apply a film of new oil to the
gasket of the new replacement filter.
Prefill the oil filter with new oil and install the new
4.
filter by hand. Turn ¾ to one full turn after the
filter gasket contacts the filter base surface.
Fill reservoir with
5.
synthetic 15W 50
oil to the
level of the lower hole in the fill tube. Do NoT
fill above the level of the upper hole. After
purging, check levels and add oil if necessary.
Reinstall the reservoir cap by hand. Do not
6.
overtighten.
Proceed to the purge procedure.
7.
Summary of Contents for GRIZZLY SE 6029FX
Page 57: ...TIMER SCHEMATIC 57 WIRING DIAGRAM...
Page 70: ...70 SERVICE JOURNAL Action Date mtr reading stamp sign...
Page 71: ......
Page 72: ...P N 115 276826R1 09 21 09...
