SPECIFICATIONS
Hand welded 11 gauge structural tubing.
All body parts are made of rotationa l molded, high density polyethylene. Front
body contains access panel for battery service. Seat lifts forward or backward
for a variety of service points in the transmission area.
13 GA stamped steel construction.
(3) blades combine for a 42" cut width.
Cut height approximately 1" to 4" via 8 position lift handle.
Electric clutch.
Each rear wheel is independently driven by chain and sprockets through a
friction, mechanical drive.
13 HP Diamond Series Briggs & Stratton, 4 -Cycle, Single Cylinder, Air-
Cooled, Gasoline, Vertical Shaft With Cast Iron Cylinder Sleeve.
Electric by key switch operation with safety interlock blade drive.
Front
410 X 3 . 5 0 X 4 ribbed tread.
Rear 18X9.50X8Turf Trac RS
Front
16-21 Ibs.
Rear
8-14 Ibs.
Fuel
2.4 gallons total.
Engine
Briggs & Stratton -1.25 quarts oil.
Kohler - 2 quarts oil with filter.
Width
47" outside rear wheel measurement.
Height
39" to top edge of seat.
Length
67" hitch tab to front bumper.
Weight
480 Ibs.
NOTE: Additional information provided in service instructions under
the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Model ZTR 4421
CHASSIS:
BODY:
MOWER DECK:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
Model 4421:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
Page 8
