SPECIFICATIONS
Model ZTR 5020
CHASSIS:
11 GA - rectangular tube
BODY:
Two piece - made of rotational molded polyethylene. Front body contains
access panels for battery service and engine to mower deck belt removal. Rear
body tilts up to allow service on the entire drive system.
SEAT:
Designed for operator comfort by use of high density closed cell foam padded
back rest and arm rests, upholstered with Cordura™ water-repellent fabric.
Seat is adjustable fore and aft.
MOWER DECK:
3 Decks are available. 42" & 60" are made of stamped steel. 50" is made of
1 1 GA fabricated welded construction with external reinforcement ribs 3
blades combine for either a 42", 50", or 60" cut width Cut height
approximately 1 .5" to 4.5" via 8 position lift handle
BLADE DRIVE:
Electric clutch
DRIVE SYSTEM:
Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
enclosed HydroGear gearbox.
ENGINE:
20HP Briggs & Stratton Intek, overhead valves, replaceable oil filter, full
pressure lube system, dual element air cleaner, integral fuel pump.
STARTING SYSTEM:
Electric by key switch operation with safety interlocks on parking brake and
blade drive clutch.
TIRES:
Front 11 X 4 X 5 smooth profile
Rear 20 X 1 0.5 X 8 Multi Trac
RECOMMENDED
TIRE PRESSURE:
Front 16-21 Ibs.
Rear 8- 14 Ibs.
CAPACITIES:
Fuel - 4.8 gallons total (dual tanks)
Hydrostat oil tank - 3 quart with in-line 10 micron filter
Hydrostat oil recommendation, refer to page 37 ,
Engine - 2 qts. SAE 30 (with filter)
DIMENSIONS:
Width 54"(42" Deck), 60"(50" Deck), 73"(60"Deck)
Height 45"
Length 72"
Weight 630 lbs.(42" Deck), 668 Ibs. (50" Deck), 685 Ibs. (60" Deck)
NOTE:
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Page 10
