Page 11
CHASSIS:
Sheet metal construction frame
BODY:
Folded sheet metal. Seat lifts up for access to battery and belt service.
SEAT:
Designed for operator comfort by use of high density closed cell foam padded
back and arm rests, upholstered with Cordura
TM
water-repellent fabric. Seat
is adjustable fore and aft.
MOWER DECK:
2 Decks are available. 60" & 48" are made of 12 GA fabricated welded
construction with 10 GA reinforcement plate. 3 blades combine for either a
48" or 60" cut width. Cut height approximately 1" to 5" via 9 position lift
handle.
BLADE DRIVE:
Electric clutch
DRIVE SYSTEM:
Each rear wheel is independently driven by a HydroGear BDU-10L Series 70
hydrostatic transmission. The hydrostatic transmissions, in turn, power a fully
enclosed HydroGear gearbox.
ENGINE:
25HP Kohler Command, 4-Cycle, V-Configuration, Overhead Valve, Air-
Cooled, Gasoline, Horizontal Shaft, Aluminum Head, and Crankcase with Cast
Iron Liners, Full Pressure Lubrication/Full Flow Filter, Pulse-type Fuel Pump,
Fixed Jet Carburetor w/Smart-Choke, Electronic Ignition, In-Line Fuel Filter,
Dual Element Air Cleaner.
STARTING SYSTEM:
Electric by key switch operation with safety interlocks on parking brake and
blade drive clutch.
TIRES:
Front
4.10x3.50x4
Rear
5.00-6x13
Drive
20-10.0x10
RECOMMENDED
Front
16 lbs.
TIRE PRESSURE:
Rear
12 lbs.
CAPACITIES:
Fuel - 5 gallons
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 25
Engine - 2 qts. SAE 10W30 (with filter)
DIMENSIONS:
Width
57-1/2”(48" Deck), 69-1/2"(60" Deck)
Height
45-1/2"
Length
96" (48” Deck), 101” (60” Deck)
Weight
960 lbs. (48" Deck), 1030 lbs. (60" Deck)
NOTE:
Additional information provided in service instructions under the individual
component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
SPECIFICATIONS
6000 Series Forward Mount
