19
OPERATION INSTRUCTIONS
GRASS HEIGHT AND CUTTING SUGGESTIONS:
Do Not Attempt To Cut Grass When It Is Wet.
If the grass is tall, place the mower deck cut height lever in the top or second notch.
"Initially" overlap cutting swaths instead of a full swath with each pass. Some applications
may require a second cutting.
Keep The Underside Of The Mower Deck Clean.
Maintain Sharp Blade(s) Throughout The Cutting Season.
As a rule of thumb, never cut off more than 1/3rd of the total grass blade length.
Correct mowing height can reduce weeds and disease by 50% to 80%.
The following grass cut heights are based on adequate moisture conditions and normal
thatch buildup in a healthy lawn. Some locations and applications may require slightly
different cut heights. If in doubt, consult your local lawn professional for assistance.
Grass Types:
Best Cut Heights:
Zoysia
2" - 2 1/2"
Blue Grass
1 1/2" - 3"
Fescue Blends
1 1/2" - 3"
St. Augustine (Mid South)
1 1/2" - 2"
St. Augustine (Deep South)
3" - 4"
Tifton Bermuda
1 1/2"
Centipede
1 1/2" - 2"
Common Bermuda
1 1/2" - 2"
Bahia/Argentina/Pensacola
2"
MOWING INSTRUCTIONS:
Be sure that deflector is properly installed on the discharge chute.
CAUTION
CAUTION
Check the area around the mower to assure there is no one near.
1. Start engine and set throttle at full speed.
2. Set desired cut height.
3. Release park brake.
4. Move control levers in and operate per the control instructions on Page 12.
5. Set RPM at approximately 1/2 speed and engage mower blades.
Summary of Contents for ZTR 8000 Series
Page 1: ...1 Page 8000 SERIES Diesel Version ZTR MOWERS Operator s Manual 2001...
Page 15: ...15 CONTROLS...
Page 34: ...34 NOTES...
