29
CARE AND MAINTENANCE
STEERING CONTROL ADJUSTMENTS (continued):
C.
To Adjust Steering Control Levers:
1.
Loosen the front and rear bolts retaining the
bellows hold down plate and slide the
bellows and plate up the steering lever to
expose the steering control mechanism.
2.
Move the levers inboard to the operating
position.
3.
Loosen the set screw of the clamp collars
which lock the upper arms to the lower arms.
4.
Raise or lower the arms for desired height.
There is approximately 3" of height
adjustment available. Upper shaft should
have a minimum of 1-1/2" engagement in
lower shaft.
5.
Rotate arms until they have the desired
orientation front to back.
6.
Tighten the clamp collar set screws.
D.
To Adjust "In" Position of the Steering Controls
1.
Move the levers inboard to the operating position. Adjust the steering lever stops until the
steering levers have the desired clearance.
E.
To Adjust for Straight Forward Tracking
1.
Drive tractor with both control levers in the full forward position.
2.
Stop the machine and shut off the engine.
3.
Adjust the forward stop of the control levers on the side which appears to be faster to
limit the forward travel of the control levers until the mower tracks in a straight line.
Note: Variations in the turf and tire pressure can cause variations in speed and tracking.
F.
When all alignment adjustments are satisfactory, slide the hold down plate and bellows down the
control levers and secure with screws.
Summary of Contents for ZTR 8000 Series
Page 1: ...1 Page 8000 SERIES Diesel Version ZTR MOWERS Operator s Manual 2001...
Page 15: ...15 CONTROLS...
Page 34: ...34 NOTES...
