INSTALLING AND REMOVING MOWER DECK FROM FRAME
1. Attach stabilizer arms to mower deck with
pins and clips as shown on drawing.
2. Attach the 1/2" dia. engaging rod with a
rollpin through the engaging cam.
3. Position the drive belt on pulleys.
4. Place mower deck under unit in approximate
operating position with engaging rod through
hole in the floor.
5. Connect drive belt to motor pulley, being
certain that belt is inside of belt guides.
Loosen belt keeper by loosening the two rear
engine mount bolts; this will allow belt to be
placed on motor pulley. Retighten engine
mount bolts.
6. Attach stabilizer arms to pivot point on the
inside of attaching plates with pins and clips.
7. Attach lift linkage to mower deck on the inside
of the attaching lugs as shown on drawing
with pins and clips. (4 places)
8. Place engaging handle on engaging rod and
fasten with bolt and locknut.
9. Connect pan wire loom plug to plug on frame
wire loom. Mower will not start unless this
connection is
.
made. To operate mower with pan removed an avail-
able by-pass (P/N 4038) must be used.
