©
2019
DJI All Rights Reserved.
7
EN
For the battery charger compatible with MG-12000P batteries:
Connect the battery’s charging and balancing port to the charging cable.
Make sure to place the charging battery on the same side that the charging cable is fixed
to the battery charger.
3. Make sure all cables are correctly connected and press the Power button on the operation
panel of the charger. The four LEDs, the warning indicator, and the quick charge and slow
charge indicators will simultaneously flash. After powering on, the only lights remaining will be
the Charging Status LEDs representing the batteries currently connected. This indicates that
the self-diagnosis is complete, and the device is working normally. For more information about
how to check if there are any errors during self-diagnosis, refer to LEDs and Warning Indicator
Description. Alternatively, connect the charger to a remote controller and launch the DJI MG app
to see detailed information about the errors.
4. If no errors are detected during self-diagnosis, the battery charger will begin to charge the
batteries. Press the Mode button to choose quick charge or slow charge mode (the default
charging mode is quick charge).
In quick charge mode, the battery charger will charge T16 batteries in order of their power level,
starting from highest to lowest. If MG-12000P batteries are being charged, the battery charger will
first charge the two batteries with the highest power level, followed by the remaining two batteries.
In slow charge mode, the battery charger will first charge the batteries with the lower power
levels. Once all batteries have the same power level, they will all be charged simultaneously.
This applies to both T16 and MG-12000P batteries
Before use, make sure there are no obvious defects on the battery charger or batteries
(e.g., jams, breakages, or short circuits).
DO NOT turn the battery charger on unless the batteries are correctly connected.
When charging MG-12000P batteries in quick charge mode, note that the battery charger
will not reorder the charging priority if a battery is removed. This may lead to only one
battery being charged rather than a pair of batteries.
