A3-AG/N3-AG AGRICULTURE KIT 2.0
User Manual
28
©
2019 DJI All Rights Reserved.
1. Record Points A and B in Order
Fly the aircraft to the starting point, depicted as Point A/B, hover, and then press Button A/B on
the remote controller or tap Point A/B onscreen. The icon for Point A/B will change from gray to
purple and the Flight Status Indicator will blink red/green after recording the starting points.
Points A and B cannot be recorded if the spray tank is empty.
Be sure to record Point A first and then record Point B and that the distance between
Point A and B should be more than 1 m.
Update Point B by flying the aircraft to a new position to record. Note that if you update
Point A, you must also update Point B.
It is recommended to keep the direction of Point A to B parallel to one side of the
rectangular spray area for optimal effect.
After recording Point A, there will be a menu prompt for operation type settings. Set
the amount of pesticide per acre, operation type, Banked Turning, etc. Use the slider
to adjust operation efficiency (affecting the flying speed and spray rate). During the
operation, tap the icon at the top of the screen to adjust parameters (Banked Turning
excluded). You can also adjust operation efficiency via the Settings dial on the remote
controller.
The DJI MG app will display an icon of line spacing after Point A and B are recorded. Tap
to adjust the value. The line spacing cannot be adjusted during operation.
2. Select the Route
After Point A and B are recorded, the app produces Route R by default. Tap Direction on the
lower right corner of the screen to switch to Route L.
3. Configuring Aircraft Altitude
Tap on top of the screen to set the desired height above the vegetation. Under optimal
working conditions, the radar module will start working automatically and maintain the spraying
distance between aircraft and vegetation after performing the operation.
4. Performing an Operation
Tap Start on the lower right corner and slide to start the operation.
If, after recording Points A and B, you fly the aircraft more than five meters away from
Point B, Resume will appear on the lower right corner of the screen. Tap Resume, and
the aircraft will automatically fly to Point B to perform the operation.
If the GNSS signal is weak during the operation, the aircraft will enter Attitude mode and
exit from A-B Route operation mode. Operate the aircraft with caution. The operation
can be resumed after GNSS signal is recovered.
If you press the A or B buttons during operation while the flying speed of the aircraft is
lower than 0.3 m/s, the data for Points A and B of the current route will be erased and
the aircraft will hover in place.
