Aeroscope
AS-F1800
10
©
2018 DJI All Rights Reserved.
b. If using G16 high-gain antennas, the 2.4GHz antenna should be connected to a 5.8GHz
antenna. Each 5.8GHz antenna has two antenna cable ports. The port marked “OUT” is
for connecting to the Aeroscope unit, and the port marked “IN” is for connecting to the
2.4GHz antenna. Below figure shows the connection configuration and close-up view of
a 2.4GHz antenna.
Connection configuration between
G8 antennas and the stationary unit
(a) The connections between the 2.4GHz antennas and the 5.8GHz antennas in G16
antennas installations. (b) The “IN” and “OUT” ports on a 5.8GHz G16 antenna.
(a)
(b)
4. Often, the supplied power cable is too short for the connection between the stationary unit
and the nearest available power outlet. In such cases, a qualified electrical engineer must
extend the initial power cable to complete the connection.
5. After powering on, check the LED indicators with reference to the Indicators section.
6. Download DJI Assistant 2.
from https://www.dji.com/aeroscope/info#downloads
7. Install and run DJI Assistant 2 on a windowns computer (desktop or laptop).
8. Connect the computer and the Aeroscope unit to the same router, or connect them directly
via the Ethernet port.
9. After the Aeroscope stationary unit is found on the DJI Assistant 2 start page, set the
server IP and Port in Network Settings>Server Network Settings.
10. Set the network mode to Wireless if using a wireless dongle. Set to Wired if using an
Ethernet connection. Depending on network provider requirements, set the parameters
manually or set the mode to Auto.
Summary of Contents for Aeroscope AS-F1800
Page 1: ...2020 10 Aeroscope AS F1800 V2 0 User Manual...
Page 2: ......
