Aeroscope
AS-F1800
©
2018 DJI All Rights Reserved.
13
Procedure 2: Extending the AC Power Cable (Original Plug Bracket)
1. Loosen the nut that seals the cable in the waterproof module, and remove the screw on
the top of the module to open it.
2. Cut off the original female plug bracket. Remove the power cable and replace it with a
longer one provided by yourself.
3. Solder the original female plug bracket onto the new power cable.
4. Insert the female plug bracket into the waterproof module and tighten the screw. Tighten
the nut to ensure a good seal between the cable and waterproof module.
Procedure 3: Converting to a DC Power Cable
Follow the procedure shown in the figure below to convert the power cable to a DC power cable.
The modification procedure is the same as that of Procedure 1 for extending an AC power cable, but different
pins are required. Connect the cable wires to the DC negative and DC positive poles on the female plug
bracket to use the cable as a DC power cable.
DC negative pole
DC positive pole
Summary of Contents for Aeroscope AS-F1800
Page 1: ...2020 10 Aeroscope AS F1800 V2 0 User Manual...
Page 2: ......
