Aeroscope
Stationary Unit Installation
©
2018 DJI All Rights Reserved.
5
4. Often, the supplied power cable is too short for the connection between the stationary unit
and the nearest available power outlet. In such cases, a qualified electrical engineer must
extend the initial power cable to complete the connection.
5. After powering on, check the LED indicators with reference to Figure 7.
6. Download DJI Assistant 2.
from https://www.dji.com/aeroscope/info#downloads
7. Install and run DJI Assistant 2 on a windowns computer (desktop or laptop).
8. Connect the computer and the Aeroscope unit to the same router, or connect them directly
via the Ethernet port.
9. After the Aeroscope stationary unit is found on the DJI Assistant 2 start page, set the
server IP and Port in Network Settings>Server Network Settings.
10. Set the network mode to Wireless if using a wireless dongle. Set to Wired if using an
Ethernet connection. Depending on network provider requirements, set the parameters
manually or set the mode to Auto.
11. Exit DJI Assistant 2.
12. Restart the stationary unit.
13. Connect the stationary unit to the internet.
a. It is recommended to always use Ethernet when possible, because the connection is
stable and free of interference.
b. If using a wireless connection, the dongle must be installed with an active SIM card.
You may need to configure some parameters such as APN in DJI Assistant 2.
14. Log into the Aeroscope web server https://Aeroscope.djiservice.org using your assigned
account. The account management system in Aeroscope manages the relations between
each account and each Aeroscope unit. Make sure the DJI admin has added your unit to
your account. Otherwise, you will not see your unit when you log in.
Importing Certificates
In most cases, when you receive your Aeroscope stationary unit the certificate should already
be imported. If the certificate doesn’t work or has expired, you will need to import a new
Figure 7. LED explanations
LED1: Processor module status
LED2: Network connection status
LED3: UAV information capture status
LED4: Type 3 receiver status
LED5: Type 2 receiver status
LED6: Type 1 receiver status
LED4
LED5
LED6
LED1
LED2
LED3
