AGRAS MG-1 User Manual
© 2016 DJI. All Rights Reserved.
14
1. Smart Operation Mode: When the aircraft is in G-Mode and the GPS signal is strong, toggle the switch to this
mode and the aircraft will fly and spray liquid in a certain route after Point A and B recorded.
2. Manual Operation Mode: In Manual Operation Mode, users can control the whole movement of the aircraft and
spray liquid via the Spray Button.
3. Assisted Operation Mode: In Assisted Operation Mode, the flying speed is restricted and the
ai aft’s headi g is
locked. Users can control the movement of the aircraft except the heading. Press Button C1 or C2 and the aircraft
ill fl o e ope atio idth to the left o ight. It sp a s li uid he fl i g fo a ds a d a k a ds. It does ’t sp a s
liquid when flying left and right.
RTH Button
Press and hold the RTH Button to bring the aircraft back to the last recorded Home Point. The
LED around the RTH Button will blink white during the RTH procedure. Users can control the
aircraft during the procedure. Regain control manually to cancel the RTH procedure. Refer to
How to Regain Control for details.
Optimal Transmission Range
The signal transmission between the aircraft and the remote controller performs best when the aircraft is within
the optimal transmission range. Open up the antennas on the remote controller to optimize transmission range.
Ideally, the flat surface of the antenna should be facing the aircraft. If the signal is weak, fly the aircraft closer to
you.
Optimal Transmission Range
Strong Weak
Remote Controller LED
The Status LED indicates the connection status between the remote controller and the aircraft. The RTH LED
indicates the Return-to-Home status of the aircraft. See the table below for details on these indicators.
Status LED
Sound
Remote Controller Status
—
Solid Red
The remote controller is not connected to the aircraft.
—
Solid Green
The remote controller is connected to the aircraft.
Blinks Red
D-D-D......
Remote controller error.
Status LED
RTH LED
