Cendence
User Guide
©
2017 DJI All Rights Reserved.
15
Customizable Buttons
Go to the Customizable Button Settings Menu in DJI GO 4. Here you can set functions for the left
lever, right lever, C1-C4 buttons, and BA-BH buttons.
Dual Remote Controller Mode
More than one remote controller can connect to the same aircraft in Dual Remote Controller mode.
The Master remote controller operator controls the orientation of the aircraft, while the Slave remote
controller controls the movement of the gimbal and camera operation. Master and Slave remote
controllers communicate each other via Wi-Fi.
In Dual Remote Controller Mode, when the Master remote controller is primary, it can
control gimbal pitch and pan. When the Slave remote controller is primary, it can control
gimbal pitch, pan, and roll.
Dual Remote Controller mode is not available in Russia and Israel.
Setting Up Dual Remote Controller Mode
Dual Remote Controller mode is disabled by default. Users must enable this feature on the Master
remote controller via DJI GO 4. Follow the steps below to setup:
Master Remote Controller:
1. Connect the remote controller to your mobile device and launch DJI GO 4.
2. Go to the Camera View and tap to enter the remote controller settings window.
3. Select Master and set the remote controller as the Master remote controller.
4. Enter the connection password for the Slave remote controller.
Master
Master ID: 28172d
Slave ID: 14f93f
Connection Status:ON
Authorization Code:
Set Remote Controller Status
Master and Slave
Remote Controller Calibration
666666
Remote Controller Settings
Slave
OFF
