©
2017 DJI All Rights Reserved.
7
Preparing the Remote Controller
Mounting/Removing the Intelligent Battery
Put the battery into the Battery Slot, then slide it to the end until you hear a click.
Press the Battery Release Button before removing the battery.
Press the Battery Level Button once to check the battery level.
Charging the Battery
The remote controller is powered by a WB37 intelligent battery, which can be charged via the
charging port or by the WCH2 Intelligent Battery Charging Hub.
Using the Charging Port
The INSPIRE
TM
2 charger is used as for example below.
Place the battery into the remote controller, and connect connector B of the battery power port, then
connect the battery charger to a power outlet (100-240V, 50/60Hz). When charging is complete, the
display on the remote controller will show 100%.
OK
Charging Time: 2 hours and 24 min
Using the Charging Hub
The Inspire 2 Charger and the WCH2 Intelligent Battery Charging Hub are used for example below.
Place the battery into the Charging Hub, and connect connector B of the battery charger to the
charging hub, then connect the battery charger to a power outlet (100-240V, 50/60Hz). The
Charging Hub will intelligently charge batteries in sequence according to battery power levels from
high to low. The buzzer will begin beeping when charging is complete. Remove the battery or turn
off the Buzzer Switch to stop it.
B
B
A
Power Qutlet
100~240 V
(50Hz/60Hz)
