Cendence
User Guide
8
©
2017 DJI All Rights Reserved.
Using the WCH2 Charging Hub, charging time is approximately 1 hour and 11 minutes (for one battery).
USB power supply port can be used to charge the mobile device of 5V/2A.
Refer to the WCH2 Charging Hub User Guide for more details.
Mounting the Monitor to the Remote Controller
Mounting the DJI CrystalSky Monitor
DJI CrystalSky7.85inch is used as example in this guide.
Ensure that Part B is
unlocked. Install Part B
into Part A.
Lock the Mounting
Bracket.
Lock the Mounting
Bracket.
Use a coin to adjust
the tightness of the
pitch axis.
B
A
Mounting the Third Party Mobile Devices
For other mobile devices (e.g. iPhones, iPads), the Cendence Mobile Device Holder and an
appropriate USB cable are required.
B
A
B
Unlock the Mounting Bracket and
mount the Mobile Device Holder.
The charging hub blinks green while charging and turns solid green when charging is finished.
Power Qutlet
100~240 V
(50Hz/60Hz)
Attach your mobile device, then tighten the clamp to secure it. Connect your mobile device to the
remote controller with a USB cable. Plug one end of the cable into your mobile device, and the
other end into the USB port on the back of the remote controller.
