©
2014 DJI. All Rights Reserved.
7
DJI DROPSAFE
User Manual
Installing System Base
Setting Up the System Base for Deployment
Ensure the "activation switch" and "safety switch" on your remote controller are turned off. Ensure the
spring and triggering pin are within the triggering housing unit. Follow the instructions below to set up the
system base:
1. Place the trigger compression tool into the triggering housing unit. Use the supplied hex
screwdriver to rotate the trigger compression tool clockwise for five times and then power on the on-
board battery. The LED indicators on system base will blink red and green for three times to indicate
the system is functional.
3. Rotate the screwdriver to tighten the trigger compression tool until the system LED blinks solid
green. Meanwhile, the other system LED will blink red for 9 seconds and then goes off.
Green system LED blinks solid.
Red system LED blinks for 9 secs.
×5
2. Press the initialization button to initialize the system. The system LED will blink solid red when the
initialization is completed. If the system LED blinks red, it indicates the signal from remote controller
or flight controller is abnormal. Ensure both the "activation switch" and "safety switch" on the remote
controller are in the OFF position and that the parachute function of your flight controller is enabled.
